Belling SCIH60 Manual de Serviço descarregar pdf (Página 16)

installation

Fitting into worktop

Cut a hole in the work surface to the

required size.

A clearance of at least 50mm should be

maintained between the cutout and any

rear or side wall.

The worktop must be of heat-resistant

material or covered with heat-resistant

material.

Protecting the cut-out;

The types of chipboard used for work

surfaces swell relatively quickly in contact

with humidity.

Apply a suitable sealant to the cut edge

to protect it from moisture ingress.

This hob can be installed conventionally

(glassabovetheworktop)orrecessed

intotheworktopforausht.

Self adhesive seal

Apply the self adhesive seal to the

underside edges of the hob glass. For

best results, the seal should be adhered

along each side in turn, as close to the

edge as possible, and trimmed at each

corner, taking care to ensure a neat join.

Conventional Installation

Place the hob in the aperture, checking

the hob glass is covering the work top

along all four sides.

Set the front edge of the appliance paral-

lel with the front of the work top.

Locate and attach the securing clamps

as required, Tighten the screws so that

thehobispulleddownrmlyagainstthe

worktop, thus ensuring a good seal.

Recessed Method

Recess the work top to the appropriate

depth(Approx5mm)andshapetotthe

hob(add1mmtooverallglasssize).

Insert the hob into the recess, ensuring

that the foam seal is sitting correctly.

Locate and attach the securing clamps

as required, Tighten the screws so that

thehobispulleddownrmlyagainstthe

worktop, thus ensuring a good seal. You

maywanttollanygapbetweenthe

hob top glass and the work top surface

with silicone sealant.

DO NOTtsiliconesealantunderthe

glass hob instead of the self adhesive

seal.

1

SELF ADHESIVE SEAL

Worktop Hob

CONVENTIONAL INSTALLATION

1

Worktop

Hob

RECESSED METHOD

2

1

2

1

SELF ADHESIVE SEAL

SILICONE SEALANT

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários