Belling IHK80 Manual de Serviço descarregar pdf (Página 22)

INSTALLATION

Clearances and dimensions – re-

quirements

1. No shelf or overhang of combus-

tible material should be closer than

650mm above the hob.

2. There must be a minimum clearance

of 50mm between the edges of the

hob and any side walls; this clearance

must be maintained up to 420mm

above the worktop.

3. There must be a minimum clearance

of 50mm between the rear edge

of the hob and the rear wall. This

clearance must be maintained up to

650mm above the worktop.

4. When installing an extractor hood

above the hob, refer to their Manu-

facturer’s instructions.

Cutout Required - 80

Width 735mm

Depth 455mm

Clearance Required

Side Wall 50mm

Rear Wall 50mm

Cutout Required - 90

Width 855mm

Depth 455mm

Clearance Required

Side Wall 50mm

Rear Wall 50mm

Fitting into worktop

Cut a hole in the work surface to the

required size. See table for relevant

dimensions.

A clearance of at least 50mm should be

maintained between the cutout and any

rear or side wall.

The worktop must be of heat-resistant

material or covered with heat-resistant

material.

Minimum height to extractor

as recommend in extractor

instruction manual

*

(

50mm Min

50mm min

420mm min

Minimum distance

between carcasses must

be equal to width of hob

*

50mm min between hob and rear wall

(>60mm to cut out aperture)

side wall

50 mm

rear wall

50 mm

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comentários a estes Manuais

Sem comentários